This section is designed for quick access to the technical figures that are often needed during repair and servicing.
Engine
- Valve clearances
- Firing orders
- Injection timing
- Compression data
Torque Settings
- Cylinder-head bolts
- Engine fasteners
- Wheel and hub fasteners
- Critical workshop torque figures
Fluids & Capacities
- Engine oil
- Transmission oil
- Hydraulic oil
- Coolant
- Fuel capacity
Hydraulic & Mechanical Settings
- Hydraulic relief pressures
- Clutch adjustment
- Brake adjustment
- PTO settings
- Linkage settings
Always check model and serial-number applicability before using a specification.
Torque Settings, Tightening Sequences & Fastener Basics
A practical reference to bolt grades, thread condition, torque-to-angle, tightening sequences, stretch bolts, wheel nuts and why critical values must come from the exact workshop manual.
Valve Clearances, Firing Orders & Engine Timing Basics
A practical reference to tappet settings, hot/cold clearances, firing orders, cylinder numbering, diesel injection timing, timing marks and safe adjustment procedures.
Hydraulic Pressure Testing, Relief Valves & Gauge Basics
A practical reference to test ports, gauge selection, oil temperature, relief valves, pressure versus flow, steering, PTO and transmission pressure checks.
Compression Testing, Oil Pressure & Engine Condition Checks
A practical reference to diesel and petrol compression tests, cylinder balance, leak-down testing, blow-by, oil-pressure checks and interpreting engine condition correctly.
Electrical Test Values – Battery, Charging & Starter Checks
A practical reference to resting voltage, cranking tests, charging checks, voltage drop, starter circuits, alternators, dynamos, earth faults and parasitic drain.
Find a Machine-Specific Guide
Use the Workshop Guide Finder to narrow guides by manufacturer, model, problem or Workshop section.
Open Workshop Guide Finder